Innovate-motorsports XD-16 Quick Start Guide Bedienungsanleitung PDF herunterladen

MTS components:

 LMA-3: Auxiliary Input #3 (AuxBox- RPM, Temp,

Duty Cycle, Acceleration, Boost/MAP): #3742

 LC-1 (Lambda Cable): #3769

 Stainless Steel Bung w/ Steel Plug” #3736

 HBX-1: Heat-sinking Bung Extender: #3729

Replacement Parts:

 Terminator Plug: #3750

 MTS 2.5mm to 2.5mm serial cable: #3760

 Serial Programming Cable: #3746

Order parts, get support, find FAQ answers, and read case

studies at www.tuneyourengine.com

Warning!

1) The Oxygen Sensor used with this device gets very hot in

operation. Do not touch the hot sensor. Do not let a hot sensor

touch a combustible surface. Do not use the sensor with or near

flammable liquids or gases. Failure to heed these warnings may

result in severe burns, explosions or fires. 2) When installed in

the exhaust, the oxygen sensor MUST be connected and

operating with the wideband controller whenever the car is

running. An un-powered oxygen sensor will be quickly damaged

when exposed to hot exhaust gases.

XD-1

QUICK START GUIDE

The complete instruction manual is on the CD

Warning!

1) The Oxygen Sensor used with this device gets very hot in operation. Do not touch

the hot sensor or let a hot sensor touch a combustible surface. 2) When installed in

the exhaust, the oxygen sensor MUST be connected and operating with the wideband

controller whenever the car is running. An un-powered oxygen sensor will be quickly

damaged.

1 2

MTS components:  LMA-3: Auxiliary Input #3 (AuxBox- RPM, Temp, Duty Cycle, Acceleration, Boost/MAP): #3742  LC-1 (Lambda Cable): #3769  Stainl

Seite 2

The complete instruction manual is on the CD XD-1 QUICK START GUIDE 1. If not using a gauge pod, cut a 52mm hole into the intended dash location.

Keine Kommentare

Innovate-motorsports XD-16 Quick Start Guide Bedienungsanleitung